4 Ft Trac 2 Circuit

Low-Profile, two-circuit trac sections for surface or pendant mounting. Provides two separate 20-amp circuits from a single electrical feed or one 20-amp circuit controlled by two switches. I-beam cross section provides added strength and rigidity in pendant suspended applications. Compatible with a full range of feed, connector and mounting accessories, as listed on back of this page, to complete virtually any installation requirement. Accepts all Trac-Master and Trac-Lites trac fixtures, which have a moveable hot contact to allow operation using circuit (or switch leg) 1 or 2. Extruded aluminum I beam channel. Onepiece thermoplastic insulator Injection molded polycarbonate dead-end with set screw. Standard lengths may be cut-to-length by installer. Three 12 gauge solid copper conductors. Each circuit rated 20 amps at 120 volts (40 amps total). Aluminum channel used as system ground. One-piece insulator insures consistent conductor spacing for reliable electrical contact. Insulating bushings supplied at mounting hole locations to prevent shorts to ground.